How to Fix Print Spooler Error

How to Fix Print Spooler Error

 How to Fix Print Spooler Error

To fix a print spooler error, you can try the following steps:


Open the Services window on your computer. To do this, press the Windows key + R on your keyboard, type "services.msc" into the Run box, and press Enter.


In the Services window, find the "Print Spooler" service and double-click on it to open its properties.


In the Properties window, make sure the "Startup type" is set to "Automatic" and the "Service status" is set to "Started". If the service is not started, click the "Start" button to start it.


Click the "Apply" and "OK" buttons to save the changes and close the window.


Close the Services window and try to print something to see if the error has been resolved.


If the above steps do not fix the print spooler error, you can try restarting the service. To do this, follow the steps above to open the Properties window for the print spooler service, and then click the "Stop" button to stop the service. Wait a few seconds, and then click the "Start" button to start the service again.


If the error persists, you may need to clear the print spooler queue. To do this, follow the steps above to open the Services window and stop the print spooler service. Once the service has stopped, open the C:\Windows



··

And if this article about How to Fix Print Spooler Error hasn't satisfied you yet, you can watch the video below.

That's all from SmashinGeeks, see you in another article. ^^

Previous Post Next Post